Cabletron Systems 1800 Switch User Manual


 
13-2 SmartSwitch 1800 4.0 User Guide, Rev 01
The SmartSwitch 1800 can combine voice and data frames over the same frame relay
DLCI. In the current release of software, splitting the voice and data at the other end
requires a connection to another Cabletron frame relay device (FRX4000, FRX6000,
9W004, or SmartSwitch 1800). That device must be configured with a PVC between
the network frame relay port and the frame relay port that will transmit only the voice
frames. (Once the data and voice frames have been separated in the Cabletron frame
relay device, each data frame will be routed based on the DLCI configuration and data
type.)
Required Configuration
To run Voice over frame relay in a SmartSwitch 1800, make sure the following are
properly configured:
Node parameters (Chapter 4). This is general configuration that must be done
no matter which protocols will be run in the node.
Loaded protocols (Chapter 5): Frame relay and Voice.
Frame relay (Chapter 7) port(s) that will connect to the network.
Voice system-level parameters (page 13-3)
Speed dial map (page 13-6)
Voice port(s) (page 13-8).
Voice interface(s) (page 13-16).
Voice Configuration Menu
To access the Voice Configuration Menu, press
[A]
(
Configuration
), then
[F]
from the
Main Menu.
Figure 13-1 Voice Configuration Menu
[A],[F]
from Main Menu
Node Name=node_xyz
Voice Configuration Menu
A Voice System Configuration
B Review Voice Speed Dial Map
C Configure Voice Speed Dial Map
D Configure Physical Port
E Review Voice Interfaces
F Configure Voice Interfaces
Option: