Filter
Top Products
D-2 SmartSwitch 1800 4.0 User Guide, Rev 01
Local NetView Access
The SmartSwitch 1800 supports a local NetView access function that allows the node
operator to send commands from the node to lines and PUs. This function is only
between the node and lines/PUs—the commands and responses are not transmitted to
NetView.
To display the NetView Access Options Menu, press
[H]
at the On-Line Node Opera-
tions Menu (or
[B], [A], [H]
from the Main Menu).
Figure D-1 NetView Access Options Menu
[B],[A],[H]
from Main Menu
Commands can be sent individually or via a batch file. You can also create a batch file
made up of commands you send. The supported commands are described later in this
chapter.
The various operations work as follows:
●
To send commands from the keyboard, select
Read From Keyboard
, then enter
the desired command(s). If you want to create a batch file of the commands you
send, specify the desired
Input File Name
, then specify
ON
fo r
Write To File
. If you
do not want to create a batch file, make sure
Write To File
is
OFF
.
●
To repeat the last command you entered, press
[F]
.
●
To send commands from an existing batch file, specify the desired
Output File
Name
, then select
Read From File
. The commands will be executed one at a time,
and each command after the first one will be executed only after you press
[F2]
.
Node Name=node_xyz
NetView A cc ess Op tion M enu
A Input FileName nmvtCmd.in
B Output FileName nmvtCmd.out
C Write to File OFF
D Read From File
E Read From Keyboard
F Execute Last Command
Option: