Filter
Top Products
Chapter 3
Introduction to Database Configuration
Each SmartSwitch 1800 contains its own configuration database, which contains
information identifying the hardware components, and defines the operating param-
eters of the hardware and software.
Each database file contains defining parameters for a specific component; for
example, physical ports, subscriber IDs, or IP interfaces.
Before the SmartSwitch 1800 can properly operate, all necessary database parameters
must be configured. The necessary configuration depends on the installed hardware,
the routing and access protocols that will be used, and the devices that will be con-
nected to ports in the SmartSwitch.
Database Setup Recommendations
Many database parameters are configured with default values, many of which may not
need to be changed for your configuration. Other parameters, however, define the spe-
cific configuration. For example, each device must have unique identifiers if the
device will be used in remote control, file transfer, or alarm reporting operations. Also,
each device will most likely differ in which ports will run which protocols, and what
the physical interfaces on those ports will be.
Before proceeding with your configuration, you should be aware of all the parameters
that must be, or can be, specified. You should first note the default values, since many
may be correct as is. Tables of parameters, including their valid and default values,
can be found throughout Section II. The Table of Contents contains a list of all tables.
You should also be familiar with all devices that will connect to the SmartSwitch
1800; some have requirements or restrictions.
Some things you must know before configuring the database are:
●
The information in Table 2-1 (on page 2-2).
●
The addresses that must be specified in various port and interface records. Each
SVC subscriber must be assigned an ID (described on page 8-21) that will be
used as a called or calling address in call setup packets. IP, IPX, LLC2, and
SNMP also require addresses for identification of networks and devices.
●
Passwords. You must enter a password to remotely control another SmartSwitch
1800 or some other Cabletron frame relay access device, to perform software
updates and file transfers, and to configure alarm routing.