Filter
Top Products
Chapter 6
Configuring Physical Ports
SmartSwitch 1800 ports provide access connections to devices, and routing connec-
tions to networks. Each port must be configured in the software to specify the oper-
ating parameters of the hardware and the protocol that will run on the port.
The SmartSwitch 1800 supports physical ports, as well as logical X.25 ports, which
run on a physical frame relay port. Configuration of logical ports is described in
Chapter 8.
Locations of Physical Ports
Figure 6-1 Physical Ports on Voice Models
The physical interfaces on Voice models of SmartSwitch 1800 are as follows:
●
The CSU/DSU port is RJ48C.
●
The LAN port, provided in two interface types, depends on the model:
◆
Ethernet – RJ48 (UTP, 10BaseT) and DB15F (AUI, 10Base5).
◆
Token Ring – RJ45 (UTP) and DB9F (STP).
●
WAN ports 0 and 1 are RS-232 DTE (male) and/or DCE (female), depending
on the attached Cabletron cables. (If the optional CSU/DSU port is used, WAN
port 1 is disabled.)
●
WAN ports 2 and 3 are determined by the attached Cabletron cables: RS-232,
V.35, and/or RS-449, all available as either DTE (male) or DCE (female).
●
Voice ports 1 and 2 are RJ45.
Voice 1
Optional
CSU/DSU Port
LAN Port
WAN 0 WAN 1 WAN 2 WAN 3
Console Port
Voice 2