Cabletron Systems 1800 Switch User Manual


 
Chapter 4
Configuring Node Defaults
Node Defaults are a set of parameters that identify a SmartSwitch 1800 for purposes
of remote control, software updates, file transfers, and/or alarm reporting to or from
other Cabletron frame relay access devices (SmartSwitch 1800, 9W004, FRX4000,
FRX6000), and define connections between the SmartSwitch 1800 and a NetView
manager device.
Press
[C]
at the Node Configuration Menu to display a screen similar to Figure 4-1.
This is the first of three Node Defaults screens—pressing
[PgDn]
or
[PgUp]
will change
the display among the three screens.
The first two screens contain parameters that apply to all users. The third screen con-
tains parameters used in sessions between a NetView host and the NetView service
point function in the SmartSwitch 1800. If the NetView function will not be used, the
third screen does not have to be configured.
Figure 4-1 Node Defaults Configuration Screen 1
[A],[A],[C]
from Main Menu
After making any changes, be sure to press
[F7]
to update the
system memory. Otherwise, the changes will not take effect until
the next re-boot of the SmartSwitch 1800.
Node Name=n ode_xyz
Node Defaults Configuration (Screen 1 of 3)
Database System Memory
A Node Name node_xyz node_xyz
B Remote Control ID
C Remote Control Pwd
D File Transfer ID
E File Transfer Pwd
F Collecting SmartSwitch ID
G Collectin g SmartSwitch Pwd
H Primary Alarm Output ID
I Primary Alarm Output Pwd
J Secondary Alarm Output ID
K Secon dary A larm Output Pwd
Option: