Cabletron Systems 1800 Switch User Manual


 
Configuring IP Routing 14-5
Figure 14-2 IP Interface Record – Frame Relay Example
[A],[C],[E],[B]
from Main Menu
Destination IP Address
is displayed only if
Enable Inverse ARP
is
N
.
Source IP Address
is displayed only if
Unnumbered Interface
is
N
.
Some changes to IP Interfaces and Static Routes (described later) require
an extra step to update the SmartSwitch software. Changing certain param-
eters will generate the message:
Dynamic Routing Parameters have
changed. ............. Do you wish to update them at this time Y/N (N)?
This must
be done, but if you are making several changes to IP Interfaces and Static
Routes, you can save time by specifying
N
for each change until the final
one. Entering
Y
after the final change will update all changes made to both
IP Interfaces and Static Routes.
If you forget to specify
Y
after the last change, you can still update the
SmartSwitch 1800 via
On-line Update Dynamic Routing Parameters
,
[G]
at
the IP/LLC2/BRIDGE/IPX Defaults Configuration menu (or
[A], [A], [E],
[G]
from the Main Menu).
If the
Interface Type
is
Ethernet
,
802.3
, or
802.5
, there will be a menu item called
Con-
figure Secondary Addresses
. Selecting this item will display a screen similar to the
following.
Node Name=n odexyz
IP Interface Configuration
* Interface Number: 10
A Maximum Transmission Unit 4096
B Routing Metric Count 0
C ICMP Redirects Y
D RIP Support 0 Enabled
E RIP Flash Updates (sec) 60
F RIP Full Updates (sec) 120
GPriority 5
H Bandwidth Allocation Group 1
I Interface Type FRL
J Source Card 0
K Source Port 0
L Source DLCI 16
M Enabl e I nve rs e ARP N
N Destination IP Address 100.100.2.1
O Unn umbered I nte rfac e N
P Source IP Address 100.100.2.2
Q Network Mask 255.0.0.0
Option: