12-8 SmartSwitch 1800 4.0 User Guide, Rev 01
Profile Name
is a name given to the async PAD's "profile." If login is not required (as determined in
the Port record), the profile specified in Port record is always in effect. If login is
required, the profile specified in the PAD Login record becomes effective at login,
even if it is different from the profile specified in the Port record.
If the profile specified is not defined in the database, the default profile,
90
, will be in
effect. (See "Configuring Async PAD Profiles" on page 12-2.)
Configuring Async Port Records
Once the necessary Node, Line Processor, and protocol parameters have been con-
figured, press
[A]
at the Port Configuration Menu (or
[A], [C], [A]
from the Main Menu.
When prompted, enter a port number (or press
[Enter]
to accept the default of
0
). Valid
port numbers depend on the model of SmartSwitch 1800—see port locations on
page 6-1.
The display for an existing port will show the configured parameter values, while the
display for a new port will show default database values. (See Table 12-3 on page 12-
9.) The following figure is an example of an existing port.
Figure 12-2 Async PAD Port Screen
[A],[C],[A]
from Main Menu
If a record does not exist for the async PAD profile identified by
Initial
Profile Name
, the letter
U
will be displayed preceding the name in the
Database
column.
After making any changes, be sure to press
[F7]
to update the
system memory. Otherwise, the changes will not take effect until
the next re-boot of the SmartSwitch 1800.
Node Name=n odexyz
Async PAD Port Parameters
* Port: 0 Link State: Linkup
* I/O:–RS-232
Database System Memory
A Port Type Async PAD As ync PAD
B Physical Port Interface RS-232 RS-232
C Blocked Port Flag N N
D X.3 Line S peed au tobaud autobaud
E Initial Profile Name 90 90
F Login Required N N
G Par i ty 0,none 0, none
H DCE Cable Attached N N
I Mask Link Alarms N N
J X.25 Parameter Options
K Autocall Options
L Browse Profile
M Modem Signal Options
N Disconnect Options
O Async PAD Options
Option: