Filter
Top Products
Configuring IPX 15-11
X.25 Interface Parameters
1
Valid LAN interface depends on hardware model. Default value is
Ethernet
or
802.5
(depending on hardware) for Interface
0
, and
FRL
for Interface
1–63
.
2
If set to greater than
0
(see note 4),
RIP Age Timer
must be 3 times longer than
Periodic
RIP Timer
, and
SAP Age Timer
must be 3 times longer than
Periodic SAP Timer
.
3
A value of
0
disables aging.
4
The addresses specified here must also be configured in Subscriber records, with certain
requirements. These are described on page 8-20.
Table 15-8 IPX X.25 Interface Parameters
Parameter Valid Values Default Value
Blocked Port Flag Y/N N
Interface Type
X. 25
Depends on inter-
face number
1
Frame Type TYPE_II TYPE_II
Maximum Transmission Unit
(frame size)
31–4096
(bytes)
4096
IPX Network Address 1–fffffffe 00000000
Priority 0–9 5
Bandwidth Allocation Group 1–16 1
Port Diagnostics Enabled Y/N N
NetBIOS Enabled Y/N N
NetBIOS Hops 0–25 5 8
Periodic RIP Enabled Y/N N
Periodic RIP Timer
(seconds)
1–65535
2
60
Periodic SAP Enabled Y/N N
Periodic SAP Timer
(seconds)
1–65535
2
60
RIP Enabled Y/N N
RIP Age Timer
(seconds)
0–65535
2,3
180
RIP Maximum Size
(bytes)
54–446 446
SAP Enabled Y/N N
SAP Age Timer
(seconds)
0–65535
2,3
180
Transport Time
(55ms ticks)
1–255 1
Serialization Enabled Y/N N
Watchdog Spoofing Enabled Y/N N
IPXWAN Enabled Y/N N
Source Subscriber
valid subscriber address
4
none
Destination Subscriber
valid subscriber address
4
none
SVC Retry Timer
(seconds)
5–60 20
SVC Idle Timer
(minutes)
0–5 1
Max VCs to Establish 1–8 1
PVC Connection Y/N N
(continued)