Cabletron Systems 1800 Switch User Manual


 
Configuring SNA 9-5
After entering a station address, a screen similar to the following will be displayed.
Figure 9-3 SDLC PU Subscriber Parameters Screen
An SNA TPAD subscriber can specify only one remote device, which can
be an HPAD or an X.25 connection to the host. An HPAD subscriber can
specify up to 16 remote devices, any of which can be a TPAD or an X.25
connection to the host. An XPAD subscriber can specify only one remote
device, which must be another XPAD.
If SDLC/LLC2 conversion will be done on the PU connection, specify
[Y]
for item J
in Figure 9-3, then press
[K]
to configure the LLC2 parameters (listed in Table 9-2).
(If the PU is not part of an SDLC/LLC2 connection, you do not have to configure
those parameters.)
Node Name=nodexyz
SDLC PU Subscriber Parameters (screen 1 of 2)
* Port 0 Station Addres s C1
A PU Name name
B Local Subscriber ID 110001010100
C Remote Subscriber ID 100001000001
D Maxdata (Max I-Frm bytes/frame) 265
E Autocall Y
F Autocall Retry Time 60
G Autocall Retry Count 0
H Istatus Active
I LPDA Resource ID 0
J LLC2 Connection N
K Configure LLC 2 Parameters
L L2 DatMode Two-way Alternate
Option: