Filter
Top Products
3-12 SmartSwitch 1800 4.0 User Guide, Rev 01
E Configure IP/LLC2/BRIDGE/IPX Interfaces
A Review IP Interfaces
– (Chapter 14) displays information on any
IP interfaces (see below) configured in the SmartSwitch.
B Configure IP Interfaces
– (Chapter 14) specifies addressing and
operating parameters for IP interfaces (X.25, frame relay, or LAN).
C Review Bridge Ports / LLC2 Interfaces
– (Chapter 9, Chapter 16)
displays information on any bridge or LLC2 interfaces (see below)
configured in the SmartSwitch 1800.
D Configure Bridge Ports / LLC2 Interfaces
– (Chapter 9,
Chapter 16) specifies location, type, and format of any bridge or
LLC2 interfaces.
E Review IPX Interfaces
– (Chapter 15) displays information on
any IPX interfaces (see below) configured in the SmartSwitch.
F Configure IPX Interfaces
– (Chapter 15) identifies any IPX
interfaces. Identifies type (X.25, Ethernet, etc.) and operating
parameters.
F Configure BSC Devices
(Chapter 10)
A Review BSC Device Configuration
– displays information on any
BSC Interactive devices (see below) configured in the SmartSwitch.
B Configure BSC Devices
– identifies devices using SmartSwitch
ports configured as BSC Interactive.
D Configure Connections and Routing Paths
A Review Subscriber IDs
– (misc. chapters) displays information on
any subscriber IDs (see below) configured in the SmartSwitch.
B Configure Subscriber IDs
– (Chapter 8 and misc. chapters)
identifies end users of the SmartSwitch, and specifies parameters for
redirecting traffic to other ports.
C Review Abbreviated Addresses
– (Chapter 12) displays information
on any abbreviated addresses (see below) configured in the
SmartSwitch.
D Configure Abbreviated Addresses
– (Chapter 12) specifies short
versions of subscriber IDs that can be used in place of the full
addresses for async PAD subscribers.
E PVC Configuration
– (Chapter 7 [frame relay], Chapter 8 [X.25],
Chapter 12 [async]) displays/specifies "permanent" connections
between SmartSwitch 1800 ports.
A Review PVC Configuration
B Configure PVCs
F Review IP Routing
– (Chapter 14) displays information on any IP
routes (see below) configured in the SmartSwitch.
G Configure IP Routing
– (Chapter 14) defines routes for IP traffic
through the SmartSwitch 1800.
H Review IPX Routing
– (Chapter 15) displays information on any IPX
routes (see below) configured in the SmartSwitch.
I Configure IPX Routing
– (Chapter 15) defines routes for IPX traffic
through the SmartSwitch.
E Configure Frame Relay Backup Groups
– (Chapter 7) allows creation of
one or more frame relay ports/DLCIs that will act as backup(s) for a
port.
A Review Frame Relay Backup Groups
B Configure Frame Relay Backup Groups