Filter
Top Products
14-4 SmartSwitch 1800 4.0 User Guide, Rev 01
IP Node Defaults Parameters
RIP Version
determines the version of RIP that will be supported in the SmartSwitch 1800.
RIPv1
and
RIPv2
are incompatible with each other on the same network; however, each is
compatible with
RIPv1 Compatibility
. If transitioning a network from RIP Version 1 to
Version 2, reconfigure each device to
RIPv1 Compatibility
, until all devices are con-
figured for
RIPv1 Compatibility
. Each device can then be configured for
RIPv2.
Configuring IP Interfaces
An IP interface allows the Internet Protocol to be executed over a frame relay, X.25,
Ethernet, or Token Ring interface.
To display all IP interfaces configured on the node, press
[A]
at the Configure IP/
LLC2/BRIDGE/IPX Interfaces Menu (or
[A], [C], [E], [A]
from the Main Menu).
To configure an interface, press
[B]
at the Configure IP/LLC2/BRIDGE/IPX Inter-
faces Menu. When prompted, enter an interface number:
0–256
. (This is merely a
sequential number to identify the interface.)
It is a good idea to configure the LAN IP interface as interface
0
. This
ensures that the default IP address used for "un-numbered" interfaces will
always be the same. (See "Unnumbered Interface" on page 14-11.)
The display depends on the interface; the following figure shows an example, and
Table 14-2 through Table 14-4 list the parameters for all interface types.
Table 14-1 IP Node Defaults Parameters
Parameter Valid Values Default Value
RIP Version RIPv1, RIPv2, RIPv1 Compatibility RIPv1