Filter
Top Products
FRM Configuring Frame Relay 7- 23
active before the timer expires, the software will search the backup group for the next
available backup.
ProtEnab
enables (if
Y
) the backup protocol on the specified DLCI. It should be set to
Y
if (and
only if) the remote device is a Cabletron frame relay access device with the backup
protocol enabled on the remote DLCI connected to this backup group entry.
The remote node must be the same one to which the primary DLCI was connected.
Also, if the remote node i s an FRX6000 or FRM, its backup DLCI must be on the same
RLP as its primary DLCI (or a PVC must be configured between the two DLCIs). The
primary DLCI in the initiating node must have the remote node's primary RLP/port/
DLCI configured in its DLCI parameters.
Delete?
deletes the entry. When asked to confirm, press
[Y]
. Any entries with higher sequence
numbers will move up one to fill the gap.