Introduction to System Operation 18-3
G Unquiesce a Port
– Cancels the
Quiesce a Port
command (only if there are
still active connections on the port).
H Unquiesce a Range of Ports
– Unquiesces a specified group of same-type
ports.
C On-Line Database Operations
– (Chapter 19) backs up database and/or system
files locally or remotely.
A Back up the Current Database to a Remote FRX6000
B Back up the Current Database to a Remote FRX4000/SmartSwitch 1800
C Restore the Backed-Up Database to a Remote FRX4000/SmartSwitch 1800
D Back up the Database to a Local Directory
E Restore the Database from a Local Directory
F Back Up the Current System Files to a Local Directory
G Restore the System Files from a Local Directory
D Test X.25 Address Translation Templates
– (Chapter 8) Tests templates to
assure they were correctly created.
E Re-Load Initialization to Async Console
– (Chapter 19) Sends default terminal
settings to an Auxiliary Console on the node's Console port.
F IP Ping Connectivity Test
– (Chapter 19) Uses the Ping function to determine
whether an IP host is reachable.
G On-Line SDLC PU Operations
(Chapter 9)
A Disable an SDLC PU
– Takes any SDLC PU in the node off line.
B Disable a Range of SDLC PUs
– Takes a group of PUs off line.
C Enable an SDLC PU
– Brings any SDLC in the node on line.
D Enable a Range of SDLC PUs
– Brings a group of PUs on line.
H NetView Access
– (Appendix D) allows a NetView manager to obtain
information on the node via NMVT commands or from files in the node
database.
I CSU/DSU Tests
– (Chapter 19) (valid only if the internal CSU/DSU port is
installed).
A Self Test
– transmits a test pattern to the analog portion of the circuitry and
loop the pattern back to itself.
B Pattern Generation Test
– transmits a PRBS (pseudo-random bit sequence)
test pattern to the remote device, which will loop the signals back.
J Frame Relay Backup Operations
– (Chapter 19) allows manual switching from
a primary frame relay DLCI to its backup, or from the backup to the primary.
A Initiate Switching Primary DLCI Over to its Backup
B Initiate Switching DLCI Back to the Primary
C Status Displays
(Chapter 20)
A Node Status
– displays performance and link status for the node.
B Port Status
– displays port type, operational status, and link states for all ports
on the node.
C Virtual Connections
– displays DLCIs/LCNs, link states, subscribers, and
(frame relay only) performance for all logical connections.
D Port Signals
– displays configuration data for each port in the node, and shows
on/off status of each signal at the interface.
E Traffic Monitor
A Port Monitor
– displays control and information data of all level-3 packets
passing through a specified port.
B LAN Capture Status and Control Menu
– allows configuration of parameters
that specify information to be captured when monitoring LAN traffic.
C LAN Capture Review
– displays captured LAN monitor information.