Cabletron Systems 1800 Switch User Manual


 
4-6 SmartSwitch 1800 4.0 User Guide, Rev 01
Alarm Autocall Timer
specifies the frequency with which the SmartSwitch will attempt to establish an alarm
connection with its
Primary Alarm Output ID
during initial call setup or after the pre-
vious alarm connection is cleared.
Alarm Max Retries
is the number of times the SmartSwitch will attempt to establish an alarm connection
with its
Primary Alarm Output ID
during initial call setup or after the previous alarm
connection is cleared.
If the value specified is greater than
0
, the
Alarm Autocall Timer
will be used until the
maximum retry value is reached. If the connection is still not established, a retry will
be made once every hour.
NetView Parameters
1
Up to 10 characters can be entered, but only the first 8 will be recognized by NetView.
2
Be aware that some NVMTs are larger than 265 bytes, so you may want to set the value
higher.
3
In multiples of 4.
4
Must be less than the value for
T1
to ensure that the remote link station will receive the
delayed acknowledgment before
T1
expires.
Name
is the VTAM PU name that will identify the SmartSwitch 1800 as a NetView Service
Point.
Local Subscriber ID
is a subscriber address for the local end of an LLC2 session established for a NetView
connection. An LLC2 Host record (described in Chapter 9) must be created, with
Table 4-2 NetView Parameters
Parameter Valid Values Default Value
Name
up to 8 characters
1
none
Local Subscriber ID
0–15 characters none
Remote Subscriber ID
0–15 characters none
Maximum Bytes per Frame 25–4105 265
2
Local SAP Address 0–f c
(hex)
3
04
Local MAC Address 0–ffffffffffff 0000000 00000
IDBLK 0–fff 000
IDNUM 0–fffff 00000
T1 0–250
(x 100 msec)
10
(1 sec)
T2 100–5000
(msec)
4
100
Ti 1–50
(sec)
30
N3 1–127 1
Tw 1–127 1
N2 0–255 8
Priority 0–9 0
Bandwidth Allocation Group 1–16 1