Filter
Top Products
Configuring X.25 8-25
Redirect on Busy
will redirect calls (if
Y
) according to the Redirection Addresses if the current sub-
scriber has no LCNs available.
Redirect on Out of Order
will redirects calls (if
Y
) according to the Redirection Addresses if the if the current
subscriber’s port is out of order.
Connection Priority
prioritizes this subscriber for intra-nodal traffic; the higher the number, the higher the
priority. (This priority has no effect on traffic exiting a node.)
Priorities are configured on all logical interfaces that use a physical frame relay port.
The device processor in the node uses these priorities to help determine the order in
which it will process protocols.
When configuring priorities, be careful to consider the types of
traffic being routed on other connections in the node.
1st,2nd,etc. Path Configured
includes or excludes the associated port as a routing path to the subscriber device. At
least one path must be specified.
Port
identify the RLP(s) and port(s) that make up the routing path(s).
Redirection Address 0,1,etc.
are up to five subscribers that will be called according to the specified redirection
option. The SmartSwitch 1800 can redirect an X.25 call to an alternate subscriber if
the original subscriber cannot be reached. (See "
Redirect on Busy
" and "
Redirect on
Out of Order
." )
The SmartSwitch 1800 will call each address in the list until one is reached. If
Sys-
tematic Redirection
is enabled, the SmartSwitch 1800 will not call the original called
subscriber, but will start immediately with the first subscriber in the redirection list.