Filter
Top Products
A-4 SmartSwitch 1800 4.0 User Guide, Rev 01
ERR
– is a response to an invalid command.
ERR NC
– indicates a network congestion error.
FRAMING ERROR
– indicates that the port is not finding the stop bit at the end of the
character bits. This can be due to noise or a mismatch in such parameters as speed,
bits/character, or stop bits between the port and its connected device.
LINE DISCONNECTED
– indicates that modem signals on the port were dropped to
effect a physical disconnection.
login
– is a request to enter a subscriber ID.
LOGIN ACC
– indicates that login was successful and the user is now connected to the
network.
LOGIN REJ
– indicates that login was unsuccessful.
LOGOUT ACC
– is displayed when the PAD accepts a logout command.
LOGOUT REJ
– is displayed when the user attempts to log out, but either the Port
record was not configured to require login, or a VC on this port has not yet been
cleared.
OVERRUN ERROR
– indicates that the PAD is unable to cope with the rate at which
characters are being received by the port, resulting in loss of characters. Enabling
XON-XOFF flow control (async PAD profile parameter 5) usually corrects this error.
PAGE
– indicates that a “page wait” condition (async PAD profile parameter 22) has
occurred.
PARITY ERROR
– indicates a parity error on the port, due to either noise on the channel
or an incompatibility between the parity settings of the port and its connected device.
password
– is a request to enter a password.
PROF ACC
– means the async PAD profile was accepted.
PROF REJ
– means the async PAD profile was rejected.
PVC ERR
– indicates that a
Clear
was received on a PVC port, suggesting a possible
abnormality in the port configuration.
RESET
– indicates a
Reset
received from the network.
RESET DTE
– means that the network has received a
Reset
from the remote DTE.
SET CMD DISALLOWED
– means
Set Command
was not allowed.
STAT ENGAGED
– is a response to the
Status
command, indicating that a VC is cur-
rently set up on the port.
STAT FREE
– is a response to the
Status
command, indicating that no VC is currently
set up on the port.
TRANSFER “nnnn” COM
– indicates a called DTE reselection by the PAD to
“nnnn.”