Filter
Top Products
17-4 SmartSwitch 1800 4.0 User Guide, Rev 01
Configuring Trap Routing
The "trap" task allows the SNMP manager to specify one or more IP addresses (up to
sixteen) to which the node's events (alarms) will be sent (as SNMP traps). To con-
figure trap routing, press
[C]
at the SNMP Configuration Menu.
Figure 17-3 SNMP Trap Routing Menu
[A],[A],[D],[C]
from Main Menu
To configure an entry, press the corresponding "
Seq
" (sequence) number. To delete an
entry, select it, then press
[E]
(and
[Y]
when asked to confirm). All entries below a
deleted one will move up one in the list.
If running IP over a frame relay port with link layer man-
agement (LMI or Annex D), initial IPL traps will be lost by the
time the frame relay DLCI comes up.
Trap Routing Parameters
Table 17-3 Trap Routing Parameters
Parameter Valid Values Default Value
Address
valid IP address
0.0.0.0
Enabled Y/N N
Severity 1–4 4
Node Name=node_xyz
Trap Routing
A Seq B Address C Enabled D Severity E Delete
1 255.255.255.255 Yes 1
2 123.123.123.123 Yes 1
3 0.0.0.0 No 4
4 0.0.0.0 No 4
5 0.0.0.0 No 4
6 0.0.0.0 No 4
7 0.0.0.0 No 4
8 0.0.0.0 No 4
9 0.0.0.0 No 4
10 0.0.0.0 No 4
11 0.0.0.0 No 4
12 0.0.0.0 No 4
13 0.0.0.0 No 4
14 0.0.0.0 No 4
15 0.0.0.0 No 4
16 0.0.0.0 No 4
Option::