Filter
Top Products
Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
1-62 GR2K-GA-0014
Ver. 07-02
The flow control type can be divided largely into 13 control types.
Control 1:
Determines the priority using the output priority.
Control 2:
Determines the priority using the output priority and performs surveillance on
the contract band. If the detected flow breaches the contract band, abolishment
processing is performed.
Control 3:
Determines the priority using the output priority and performs surveillance on
the contract band. If the detected flow breaches the contract band, the priority is
lowered.
Control 4:
Rewrites DSCP and uses it to determine the priority.
Designation
of operation
Contract band upc <kbps> upc_burst
<Byte>
√
(*1)
√
(*1)
√√√√
min_rate <kbps>
min_rate_burst <Byte>
-- -- √√√√
max_rate <kbps>
max_rate_burst <Byte>
-- -- √√√√
Output priority priority <No.> √√√√√√
Queuing priority discard <No.> √√√√√√
DSCP rewrite replace_dscp
<DSCP_Value>
√
(*2)
√
(*2)
√
(*2)
√
(*2)
√
(*2)
√
(*2)
Decision of priority
by using DSCP of
input IP packet.
dscp_map
√√√√√√
Abortion at contract
band breach.
penalty_drop √√√√√√
Queuing priority at
contract band
breach.
penalty_discard <No.>
√√√√√√
DSCP rewriting at
contract band
breach.
penalty_dscp
<DSCP_Value>
√√√√√√
exp rewrite
[ROUTE-OS7]
replace_exp
<EXP_Value>
-- -- √√√√
Connection branch index <No.> -- -- -- √ -- √
Group number -group -- -- -- -- --
√
User priority rewrite -replace_user_priority
<No>
-- -- -- -- -- √
√
: Canbeset.
-: Cannot be set.
*1: Cannot be set for -upc_burst<Byte>
*2: Can be set for unicast. Cannot be set for multi-cast..
*3: RP-C cannot be set.
*4: Only GR2000-1B, GR2000-2B and GR2000-2B+ can be set.
Table 1-36 List of Parameters that Can Be Set for Each RP Type Using IPv4 QoS
Information (continued)
Item
Parameter
RP-A1 RP-C, RP-D
RP-C6, RP-D6,
RP-CV, RP-DV
Main Item Sub-Item
Input
Side
Output
Side
Input
Side
Output
Side
Input
Side
Output
Side