Filter
Top Products
Configuration Error Messages
GR2K-GA-0014 5-59
Ver. 07-02
pim: invalid max-interfaces value at ’<Num>’ PIM-SM does not support max-interfaces values.
<Num>: The maximum number of specified interfaces
pim: mask not contiguous The specified mask for rendezvous point candidates of PIM-SM is
not continuous at bit 1. Specify a mask that is continuous at bit 1.
pim: Non-masked bits not zero for <Group
address> / <Masklen>
In the group of rendezvous point candidates of PIM-SM, the
non-mask bit of the specified masklen address is set to "1." Set the
non-mask bit to "0."
<Group address>: specified multicast group address
<Masklen>: Specified mask length
pim: Non-masked bits not zero for <Group
address> mask <Mask>
In specifying a mask for the group of rendezvous point candidates of
PIM-SM, the non-mask bit of the specified address is set to "1." Set
the non-mask bit to “0.”
<Group address>: specified multicast group address
<Mask>: Specified mask
pim: Non-masked bits not zero for <Group
address> masklen <Masklen>
In specifying masklen for the group of rendezvous point candidates
of PIM-SM, the non-mask bit of the specified address is set to "1."
Set the non-mask bit to “0.”
<Group address>: specified multicast group address
<Masklen>: Specified mask length
pim: octet or hex string too long to be an IP
address
The specified IP address format is abnormal. Specify the correct dot
format.
pim:ssm is not defined Though the "ssm-join" command has been defined, the "ssm"
command has not been defined.
pim: the parameter must be a group address
(class D)
The group address specified for rendezvous point candidates of
PIM-SM is illegal. For the group address, specify a Class-D IP
address.
pim: the total number of enable interfaces is
more than the max-interfaces value (<Num>)
The total number of interface addresses specified to be enable in the
pim definition has exceeded the value specified by max-interfaces
(<Num>). Specify the addresses so that the number of interface
addresses specified to be enable is less than the value specified by
max-interfaces (<Num>). The maximum value for the max-interfaces
is 256. If addition of the interface definition for PIM is wanted, add the
definition after having increased the value of the max-interfaces.
If deletion the interface definition of PIM is wanted, delete the
interface definition so that the number of interface addresses
specified to be enable is less than the value of the max-interfaces
(<Num>).
<Num>: Specified number of the maximum interfaces.
Table 5-6 Multicast Router Control Information Error Messages (continued)