Filter
Top Products
Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
5-38 GR2K-GA-0014
Ver. 07-02
network-filter: invalid {inet|IPv6} mask bits
value at <Masklen> not in range 0 to {32|128}
At masklen/prefixlen. the mask length is valid. Specify value within
the range of 0 to 32/128.
<Masklen>: Specified mask length
network-filter: invalid low end of range value
at <Value> not in range 0 to {32|128}
In the between specification, lower limit value of mask range is
invalid. Specify a value within the range of 0 to 32/128.
<Value>: Lower limit of specified mask range
network-filter: invalid network-filter number
value at <Value> not in range 1 to 65535.
ID number is out of valid range. Specify value within the range of 1 to
65535.
<Value>: Specified ID number
network-filter: invalid octet value at <Value>
not in range 0 to 255
More than 255 values are defined in dot notation. Specify value
within the range of 0 to 255.
<Value>: Specified value
network-filter: IPv6 prefix cannot be linklocal
in configuration
The link local address is specified in the network address. Do not
use the link local address.
network-filter: IPv6 prefix cannot be multicast
in configuration
The multicast address is specified in the network address. Do not
use the multicast address.
network-filter: linklocal address should be
followed by %(IPv6 interface name)
An interface name is not specified in the specified link local address.
Specify an interface name with the percent (%) interposed when
specifying a link local address.
network-filter: low end of range (<Value1>
bits) is greater than high end (<Value2> bits)
In the between specification, lower limit of the mask range is greater
than upper limit. Reduce lower limit value of the mask range to less
than upper limit value.
<Value1>: Lower limit of mask range
<Value2>: Upper limit of mask range
network-filter: low end of range <Mask1>
shorter than prefix mask <Mask2>
In the between specification, lower limit of mask range is overlapped.
Correct the value so the mask range does not overlap with specified
mask.
<Mask1>: Lower limit of specified mask range
<Mask2>: Specified mask
network-filter: mask not contiguous Bit 1 of the specified mask does not continue. Use a mask where bit
1 continues.
network-filter: network-filter name "<Name>"
longer than 15 characters
The specified ID exceeds 15 characters. Specify ID by 15 or less
characters.
<Name>: Specified ID
network-filter: Non-masked bits not zero for
<Address> mask <Mask>
At mask, 1 is set to non-masked bit of the specified address. Set
non-masked bit 0.
<Address>: Specified address
<Mask>: Specified mask
network-filter: Non-masked bits not zero for
<Address> masklen <Masklen>
At masklen, 1 is set to non-masked bit of the specified address. Set
non-masked bit 0.
<Address>: Specified address
<Masklen>: Specified mask length
network-filter: out of range The parameter-specified range is exceeded in the input command
syntax. Numeric values of more than 4294967296 are contained.
Reconfirm a parameter.
network-filter: syntax error Syntax error
options: error resolving ’<Host Name>’:
Unknown host
The specified host name cannot be found. Specify the defined host
name.
<Host Name>: Specified host name
options: gen-prefix-route option can be
specified only with the composition with the
same network of the both ends of an
point-to-point interface.
A gen-prefix-route option cannot be specified when an interface in
which the network of local and remote addresses differs exists in a
point-to-point interface. Make identical the network of the local and
remote addresses in a point-to-point interface when specifying a
gen-prefix-route option.
Table 5-5 Routing Protocol Error Messages (continued)