Filter
Top Products
Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
5-104 GR2K-GA-0014
Ver. 07-02
Configuration file copy failed. Configuration file copy failed. Execute the command again after
removing the factors causing the following errors.
1. Confirm the MC card’s mounting status and the remaining
capacity in the standby system using the show mc command (*1).
2. Confirm the RM’s CPU use rate using the show “rm cpu”
command (*2).
Configuration file copy failed because cached
configuration file create failed.
Because configuration file cannot be copied to cached configuration
file, configuration file copy is failed. Execute the command again
after removing the factors causing the following errors.
1. Confirm the MC card’s mounting status and the remaining
capacity in the standby system using the show mc command (*1).
2. Confirm the RM’s CPU use rate using the show “rm cpu”
command (*2).
Configuration file do not copy to standby RM
because standby RM is not ready.
Standby configuration file copy failed. Confirm setting information
and the rest memory size of standby MC card using the show mc
command, and then execute again after eliminating causes of error.
Configuration file do not modified to standby
RM because configuration file is opened in
standby RM.
Because standby configuration information is opened, configuration
file copy failed. Close standby configuration, and then execute the
command again.
Configuration file do not modified to standby
RM because standby RM is not ready.
Because standby configuration information cannot be modified,
configuration file copy failed. Eliminate the error and execute the
command again.
1. Confirm the standby MC card’s mounting status and the
remaining capacity in the standby system using the “show me”
command (*1).
2. Confirm the RM’s CPU use rate using the show “rm cpu”
command (*2).
3. Confirm that the standby system RM board has been inserted
into this device correctly.
Configuration file is already closed. Current or spare configuration file already closed. Before entering
configuration information, open current or spare configuration file.
Configuration file is already opened,
configuration file did not copy.
Current or spare configuration file already opened. Command could
not be executed successfully. Before entering configuration
information, close current or spare configuration file.
Configuration file is already opened. Current or spare configuration file already opened. Close current or
spare configuration file.
Configuration file not found. Target current or spare configuration file not found. Specify correct
current or spare configuration file and execute again.
Configuration file save error. Current or spare configuration file cannot be saved. Using the show
mc command, check the installation status of the MC card, remaining
MC card memory and other statuses.
Current configuration file was successfully
changed. Configuration file do not copy to
standby RM because standby RM is not
ready.
Current configuration information file was copied, but because
standby RM is not started up, standby configuration information is
not copied. When updating standby configuration file, start up
standby and reflect by using config copy command.
Current configuration file was successfully
changed. Configuration file do not modified to
standby RM because cached configuration file
create failed.
Current configuration information file was copied, but because
standby configuration information cannot be copied to cached
configuration file, standby configuration information is not reflect.
When updating standby configuration file, confirm the rest memory
size of MC card by using show mc command, and then reflect by
using config command after eliminating causes of error.
Current configuration file was successfully
changed. Configuration file do not modified to
standby RM because configuration file copy
failed.
Current configuration information file was copied, but because
current configuration file cannot be copied to standby configuration
file, standby configuration information is not reflected. When
updating standby configuration file, confirm setting status and the
rest memory size of MC card by using show mc command, and then
reflect by using config command after eliminating causes of error.
Table 5-25 Other Error Messages (continued)