Filter
Top Products
Configuration Error Messages
GR2K-GA-0014 5-79
Ver. 07-02
Maximum number of QoS IP list group
configurations are already defined.
Maximum number of QoS IP group configurations are already
defined. Decrease group configuration to 256 entries or fewer.
Maximum number of QoS IPX configurations
already defined on the RP.
The maximum number of QoS IPX information per RP has already
been set. Specify QoS IPX information in 32 types or less per RP.
Maximum number of QoS IPX configurations
already defined.
Maximum number of QoS IPX configurations are already defined.
Allowed configuration number of QoS IPX information are up to
5RPs.
No such filter group name. Group name of the IP filter interface has not been specified. Specify
the group name of the specified filter group.
No such filter interface in/out flag. Inbound/Outbound flag has not set. Specify Inbound/Outbound flag.
No such filter list number. Filter list specified with IP filter group entry has not been specified.
Specify an entry number in the specified filter list.
No such insert index. An entry cannot be inserted on specified entry number. Use entry
number not exceeding the number of set entries.
No such name <name>. Specified configuration information name not found. Specify existing
definition information name.
A name of <name> configuration information.
No such QoS discard mode NIF number. There is no such QoS discard mode NIF number. Specify NIF
number of NIF other than the already set ATM.
No such QoS interface name. No such interface specified for QoS interface. Specify interface name
of an interface except the already set ATM line.
No such QoS interface queue list name. There is no such QoS queue list name specified in QoS interface.
Specify the QoS queue list name for the QoS queue list.
No such QoS IP list group entry number. There is no such QoS IP group entry number. Specify entry number
of an already specified IP list.
No such QoS IP list group name. There is no such IP group specified in QoS IP. Specify group name
of already set IP group.
No such set index. An entry cannot be set on specified entry number. Use entry number
not exceeding the set number of entries. To add entries, use the
number of set entries +1 for entry value.
No such shaper configuration. There is no specified shaper configuration information. Confirm the
specified shaper configuration information.
Payload length not specified. IP user data length has not been specified. Specify an IP user data
length or delete specification of IP user data upper limit/lower limit.
peak_rate out of range The input value exceeds the prescribed range. Set the value in the
range of 500 - 980000 in maximum bandwidth if Kbit/s is specified
and in the range of 1M - 980M if Mbit/s is specified.
phb scheduling class not specified. Band configuration value has not set. Specify band configuration
value when band configuration type is cs or af.
Policy routing IP address not specified. Next hop IP address has not been specified. Specify next hop IP
address or delete policy routing specification.
Port destination high is less than port
destination low.
Destination port number (high) is less than destination port number
(low). Specify a destination port number (high) greater than the
destination port number (low).
Port source high is less than port source low. Source port number (high) is less than source port number (low).
Specify a source port number (high) greater than the source port
number (low).
QoS discard mode NIF number not specified. NIF number in QoS discard mode has not been specified. Specify an
NIF number.
QoS interface name not specified. QoS interface name has not been specified. Specify the interface
name.
QoS interface queue list name not specified. QoS interface queue list name has not been specified. Specify a
QoS queue list name.
QoS IP in/out flag not specified. QoS IP in/out flag is not specified. Specify Inbound/Outbound flag.
Table 5-9 Filter and QoS Information (Other than Flow Information) Error Messages