Filter
Top Products
Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
1-134 GR2K-GA-0014
Ver. 07-02
1.2.7 qos-tos-map
Figure 1-8 Range of TOS-QoS Conversion Table Information Control
6. Non-IP protocol QoS control
Non-IP protocol (IPX, Bridge, HDLC, etc.) QoS control is set using three
commands: IPX QoS (qos-ipx), bridge QoS (qos-bridge), and HDLC QoS (qos-hdlc).
These define QoS control for IPX, Bridge, and HDLC protocols, respectively.
1.2.9 qos-ipx
1.2.10 qos-bridge
1.2.11 qos-hdlc
1.2.1 qos
This command sets the use and disuse of flow control. The setting of use and disuse
is enabled when the flow control is set using the old, BSD UNIX-based command
system (qos-ip-hst, quos-ip-hst-group,orqos-ip). The setting of use and disuse in this
command is disabled when the flow control is set using a flow command. Set the use
and disuse using a flow command when setting the flow control using a flow
command.
Input Format
Setting information
Modifying information
Deleting information
Displaying information
Parameters
Description: enable/disable flow control
-no:disable
Sets from qos-tos-map.
Flow Control (input)
Transmission Control
Flow Detection
: Control range of this command
Interface
(LINE,DLCI, etc.)
Route Search
Priority Determination
TOS Rewrite
Contracted Bandwidth
Monitoring
Queue Control
Flow Control (output)
Flow Detection
Priority Determination
TOS Rewrite
Contracted Bandwidth
Monitoring