Filter
Top Products
Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
4-18 GR2K-GA-0014
Ver. 07-02
Deleting SMTP server definitions.
Deleting destination e-mail address definitions.
Deleting e-mail report definitions.
Related Configuration Object
Precautions
1. It is necessary to have a GR2000 Product Support Service (PSS) contract in order
to us this function. Contact our sales department for information regarding PSS
contracts. It is also necessary to connect the device to a network environment
that enables e-mail transmissions via the Internet.
2. It is possible to set a maximum of 1 entry for local e-mail address, SMTP server
and destination e-mail address.
3. When using e-mail reports, it is necessary to set the local e-mail address, SMTP
server and destination e-mail address. Set, change or delete the destination
e-mail address after setting the local e-mail address and SMTP server.
4. Confirm fully that the SMTP server settings (host name or IP address, port
number) coincide with the SMTP settings of the connection destination. The
message is discarded if the connection with the destination SMTP server fails
when sending an e-mail report.
5. Confirm fully that the e-mail address settings coincide with the settings in the
SMTP server definition. The message is discarded if the e-mail transmission fails.
6. This function is only usable with IPv4. Therefore, if a host name that only has an
IPv6 address defined in the SMTP server by "hosts" (host name information) is
specified, e-mail reports to the server destination is discarded.
7. Host name of this device must be predefined by dns_resolver hostname.
8. If this command is inputted in the cases where changes are made on the IP
routing protocol information, the IP multicast protocol information, and the
MPLS information, and the apply command is not being executed, the apply
subcommand is executed before the command is executed, and the changed IP
routing protocol information, IP multicast routing protocol information, and
MPLS information are reflected to the operation.
9. Do not set the local e-mail address that is set in the device in any other device on
thenetwork. Ifitisset,itmaynotbepossibletosende-mailmessages
depending on the SMTP server, etc.
10. When using e-mail messages and log e-mail simultaneously, do not set more
than 1 entry for log e-mail destination address and 1 entry for SMTP server. If
defined with more than 1 entry, e-mail transmissions may be delayed several
minutes beyond the set time due to entry count and the load conditions of the
SMTP server used for log e-mail and e-mail messages.