Filter
Top Products
Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
4-52 GR2K-GA-0014
Ver. 07-02
Table 4-14 List of Default Values That Can Be Set Using IP Information and Default
Values During Initial Installation
Information
Group Name
Information Name Initial Value
IP interface
information
ARP cache table aging time 30 minutes
Interfacetype(ValidonlyforATM/
Frame-Relay.)
Broad-type
Proxy ARP response No proxy ARP response is made.
Encapsulation format of ARP request
frame (Hardware type)
ethernet
Maximum number of transmission retries
in ARP request frame
4times
Transmission retry interval of ARP request
frame
2 seconds
Relay of IP packets with source route
option
IP packets with a source router option are
relayed.
ICMP redirect message transmission
switch
Transmit
ICMPv6 redirect message transmission
switch
Transmit
Direct broadcast relay switch Not relayed.
Subnet broadcast relay switch Not relayed.
Non-response option of ICMPv6 node
information query
• The initial value responds.
ip_icmp6_nodeinfo_query
• To set a non-response option, execute
the following.
ip_icmp6_nodeinfo_query_off
rate limiting option (RFC2463) • ThetransmissionrateofanICMPv6
error is limited to 1 packet/
<Microsecond> (maximum).
• The initial value is enabled(500µs).
• To disable this function, set the
<Microsecond> value to "0".
• The <Microsecond> value can be set
up to 1000 in units of 0 to 10.
ARP
information
ARP hardware type Ethernet
DHCP
information
Hops threshold value 4