Filter
Top Products
Configuration Error Messages
GR2K-GA-0014 5-55
Ver. 07-02
multicast: can not set interface address at
<Address>
The interface addresses specified in the multicast definition cannot
be set. Do not specify the following interfaces because they are not
supported in the multicast.
(1) Interface of RM Ethernet
(2) Interface of AUX(RS232C)
(3) Interface in which the IP interface type is broadcast type in other
than LAN/WAN (PPP).
(4) Shared address interface.
(5) Local loop-back interface
(6) Null interface.
(7) Router device address (device address set by using the config
router command).
(8) Tunnel interface.
<Address>: Specified interface address.
multicast: duplicate group address with the
same mask at <Group address>
Interface addresses are defined in duplication in the same multicast
group address in the multicast definition. Perform specification by
using any one of the following forms so that the combination of the
multicast group address and mask will not be duplicated.
(1)<Group address>
(2)<Group address>/<Masklen> (<Masklen>: Mask length)
(3)<Group address> masklen <Masklen> (<Masklen>: Mask length)
(4) <group address> mask <Mask> (<Mask>: Mask)
Perform specification so that the definition will not be duplicated also
in the group addresses specified in the join and the staticjoin.
<Group address>: Specified multicast group address.
multicast: duplicate group address with the
same mask at <Group address> / <Masklen>
Interface addresses are defined in duplication in the same multicast
group address in the multicast definition. Perform specification by
using any one of the following forms so that the combination of the
multicast group address and mask will not be duplicated.
(1) <Group address>
(2) <Group address>/<Masklen>(<Masklen>: Mask length)
(3) <Group address> masklen <Masklen>(<Masklen>: Mask length)
(4) <group address> mask <Mask>(<Mask>: Mask ) Perform
specification so that the definition will not be duplicated also in the
group addresses specified in the join and the staticjoin.
<Group address>: Specified multicast group address.
<Masklen>: Specified mask length.
multicast: duplicate group address with the
same mask at <Group address> masklen
<Masklen>
Interface addresses are defined in duplication in the same multicast
group address in the multicast definition. Perform specification by
using any one of the following forms so that the combination of the
multicast group address and mask will not be duplicated.
(1) <Group address>
(2) <Group address>/<Masklen>(<Masklen>: Mask length)
(3) <Group address> masklen <Masklen>(<Masklen>: Mask length)
(4) <group address> mask <Mask>(<Mask>: Mask)
Perform specification so that the definition will not be duplicated also
in the group addresses specified in the join and the staticjoin.
<Group address>: Specified multicast group address.
<Masklen>: Specified mask length.
Table 5-6 Multicast Router Control Information Error Messages (continued)