Filter
Top Products
Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
1-128 GR2K-GA-0014
Ver. 07-02
8. If this command is inputted in the cases where changes are made on the IP
routing protocol information, the IP multicast protocol information, and the
MPLS information, and the apply command is not being executed, the apply
subcommand is executed before the command is executed, and the changed IP
routing protocol information, IP multicast routing protocol information, and
MPLS information are reflected to the operation.
1.1.13 filter-interface (Information on Filter Interface of Old BSD UNIX-Based
Command System)
Function
Object for creation, modification, deletion, and display of the filter interface
information. The filter group is allocated to the interface defined by the IP or
IP-address information. When the filter interface is set, the filter for the receive
packet or the transmit packet in the relevant interface is judged. A maximum of 512
filter interfaces per RP can be created.
Input Format
To create the filter interface information:
To modify the filter interface information:
To delete the filter interface information:
To show the filter interface information:
Parameter
Description: Specifies the target interface name predefined by the ip or
ip-address object.
Default: Undefined. Mandatory input other than for display. When
omitted, all filter interface information is displayed.
Description: Specifies inbound or outbound. Either one or both of inbound/
outboundcanbesetatthesametime.
-in: Inbound (specify when filtering on receive side of frame)