Filter
Top Products
Configuration Error Messages
GR2K-GA-0014 5-53
Ver. 07-02
dvmrptunnel: error resolving <Address>:
Unknown host
The interface address specified in dvmrptunnel definition is invalid.
Specify the correct interface address.
<Address>: specified interface address
dvmrptunnel: octet or hex string too long to be
an IP address
The specified IP address format is invalid.
Specify in correct dot format.
dvmrptunnel: specified remote address
<Address> belongs to the local network of this
router
The specified remote address is the local network of this device.
Use network address other than local address of this device for
remote address.
<Address>: Specified remote address
dvmrptunnel: the total number of enable
interfaces is more than the maximum
permitted (32)
The total number of the DVMRP tunnels specified in the dvmrptunnel
definition has exceeded the maximum allowance.
Specify the tunnels so that the number of definition for the DVMRP
tunnels in the dvmrptunnel definition is 32 or less.
dvmrptunnel: the total number of enable
virtual interface is more than the maximum
permitted (32)
The total of specified multicast tunnel in dvmrptunnel definition
exceeds the maximum permitted. Specify multicast tunnel definition
count in dvmrptunnel definition to 32 or less.
dvmrptunnel: tunnel <Remote address> has
bad local address <Local address>
In the dvmrptunnel definitions, there is no local address for the
specified remote address or local addresses are not supported. For
the local address, specify the defined interface address. Do not
specify the following interfaces because they are not supported in the
multicast.
(1) Interface of RM Ethernet
(2) Interface of AUX(RS232C)
(3) Shared address interface.
(4) Local loop-back interface
(5) Null interface.
(6) Router device address (device address set by using the config
router command).
(7) Tunnel interface.
<Remote address>: Specified remote address.
<Local address>: Specified local address.
dvmrptunnel: tunnel has bad remote address
<Address>
The specified remote address is invalid. Specify the correct remote
address.
<Address>: Specified remote address.
igmp: can not locate tunnel on interface The interface defined by the DVMRP tunnel cannot be defined.
Specify the interface address other than the DVMRP tunnel.
igmp: can not set interface address at
<Address>
The interface addresses specified in the igmp definition cannot be
set. Do not specify the following interfaces because they are not
supported in the multicast.
(1) Interface of RM Ethernet
(2) Interface of AUX(RS232C)
(3) Interface in which the IP interface type is broadcast type in other
than LAN/WAN (PPP).
(4) Shared address interface.
(5) Local loop-back interface
(6) Null interface.
(7) Router device address (device address set by using the config
router command).
(8) Tunnel interface.
<Address>: Specified interface address.
igmp: duplicate igmp clause The igmp definition is duplicated. Delete one definition.
igmp: duplicate interface address in list at
<Address>
The interface address in igmp is duplicated. Specify not to duplicate
interface address.
<Address>: Specified interface address
Table 5-6 Multicast Router Control Information Error Messages (continued)