Filter
Top Products
Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
1-114 GR2K-GA-0014
Ver. 07-02
Description: Specifies the destination IP address. When both destination
and source IP addresses are set under one condition, set so
that the specified addresses do not overlap. If they overlap, set
anIPaddresspairswitchasip-pair_of.(Note1)
When specifying only one IP address:
-ip_destination <IP
Address>
When specifying addresses within a range:
Specify the lower limit and upper limit of IP addresses:
Specify the subnet mask:
Specify the subnet mask length:
or
You cannot directly modify the subnet mask or the subnet
mask length for only one IP address. You must first delete the
setting by entering
delete filter-list <Filter List No.>
-ip_destination
andthenspecifytheIPaddress.
Default: Undefined.
Range of value: IP address: 0.0.0.0–255.255.255.255
Subnet mask: 255.0.0.0–255.255.255.255
Subnet mask bit length: 8–32
Description: Specifies the method for checking the source upper protocol
port number and the destination upper protocol port number.
The
-port_pair option checks for not switching and for
switching source upper protocol port number with destination
upperprotocolportnumber(seeNotelaterinthissubsection).
The
-port_pair_off option only checks for not switching
source upper protocol port number with destination upper
protocol port number. The
-port_pair option requires setting
of the synchronized pair switch for the IP address upper
protocol port number to off (
-pair_synchronized_off).
Default: On
Description: Specifies the source upper protocol port number. When both
source and destination upper protocol port numbers are set
under one condition, set so that the specified upper protocol
port numbers do not overlap. If they overlap, set an upper
protocol port number’s pair switch as -port_pair_off. (Note 1)
When specifying only one port number: