Filter
Top Products
Filtering/QoS Information
GR2K-GA-0014 1-113
Ver. 07-02
Default: None (Does not include TOS value to the condition of flow
detection.)
Range of value: 0-255
Description: Specifies the method of checking the transmission source IP
address and the destination IP address. The
-ip_pair option
checks for both switching as well as non-switching source IP
addresswithdestinationIPaddress(seeNotelaterinthis
subsection). The
-ip_pair_off option only checks for not
switching source IP address with destination IP address. The
-ip_pair option requires setting of the synchronized pair
switch for the IP address upper protocol port number to off
(
-pair_synchronized_off).
Default: On
Description: Specifies the source IP address. When both source and
destination IP addresses are set under one condition, set so
that the specified addresses do not overlap. If they overlap, set
an IP address pair switch as ip-pair_off. (Note 1)
When specifying only one IP address:
-ip_source <IP Address>
When specifying addresses within a range:
Specify the lower limit and upper limit of IP addresses:
Specify the subnet mask:
Specify the subnet mask length:
or
You cannot directly modify the subnet mask or the subnet
mask length for only one IP address. You must first delete the
setting by entering
delete filter-list <Filter List No.>
-ip_source
and then specify the IP address.
Default: Undefined
Range of value: IP address: 0.0.0.0–255.255.255.255
Subnet mask: 255.0.0.0–255.255.255.255
Subnet mask bit length: 8–32
Table 1-59 Corresponding Values -Diff-serv
2
7
2
6
2
5
2
4
2
3
2
2
2
1
2
0
DSCP CU
The six high-order bits are specified.
DSCP = Differentiated Services Code Point
CU
= Currently Unused