Filter
Top Products
Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
2-4 GR2K-GA-0014
Ver. 07-02
- IPX routing interface can be defined only to the interface that
is set IP interface (except rmEthernet, AUX, tunnel. Therefore,
IPX interface alone cannot be defined.
- Up to 160 per system and up to 32 per RP can be defined.
This value is the IPX network count. For example, when 4
types of frames are set in Ethernet, consider that 4 interfaces
are used. In WAN or ATM, only 1 interface is used.
- When the specified interface is ATM, WAN frame relay, or
ISDN, ipx-arp setting is required. (When this setting is omitted,
uni-cast communication is not available.)
- In case of WAN frame relay, set ipx_outgoing option by dlci
command to the DLCI under the target frame relay. If not, IPX
packet is not relayed.
- In case of broadcast type ISDN, stop the sending of cycle
RIP/SAP and define the necessary RIP/SAP information by
static.
Default: None (cannot be omitted)
Description: This parameter is the watchdog packet’s spoofing response
function switch. You can configure up to 160 per system and
32 per RP. Select from the following options:
Carry out the spoofing response (cycle)
Unconditionally carry out the spoofing response
Do not carry out the spoofing response
Default: Periodic
Description: This parameter is the filter function switch when the
serialization packet is received.
(Do not discard the serialization packet.)
(Discard the serialization packet.)
Default:
-serialization_filtering
Description: This parameter is the forwarding switch when the diagnostic
packet is received.
(Do not forward diagnostic packet.)
(Forward diagnostic packet.)
Default: -