Filter
Top Products
Configuration Error Messages
GR2K-GA-0014 5-63
Ver. 07-02
pim6: duplicate group prefix <IPv6 Group
Prefix> / <Prefixlen>
The prefix of the specified rendezvous point candidate has already
been defined.
<IPv6 Group Prefix>: Specified IPv6 multicast group address
<Prefixlen>: Specified prefix length
pim6: duplicate pim6 clause pim6 definition is duplicated. Delete one definition.
pim6: duplicate sparse parameter sparse definition is duplicated. Delete one definition.
pim6: global or site local address not assigned
on router local address
Unless the device address is defined, there is no setting pim6. First
set the device address.
pim6: group prefix(<IPv6 Group Prefix>) has a
narrow scope
The group address specified by the rendezvous point candidate of
IPv6 PIM-SM must have a wider scope than the link local address.
Set the scope of the group address to 3 or more.
<IPv6 Group Prefix>: Specified IPv6 multicast group address
pim6: interface <Interface Name> is already
defined
The interface address is duplicate-defined in pim6 definition.
Specify it so that the interface address is not duplicated.
<Interface Name>: Specified interface name
pim6: interface <Interface Name> not found The interface of the interface name specified in pim6 definition
cannot be found Specify the interface by the defined interface name.
<Interface Name>: Specified interface name
pim6: invalid IPv6 address: <IPv6 Address> The format of the specified IPv6 address is invalid. Specify the
address in a proper format.
<Prefixlen>: Specified address
pim6: the number of active pim6 interfaces
(<Num>) should be less than 32
The total number of enable-specified interface addresses in pim6
definition exceeds the maximum allowable number of addresses.
Specify so that the number of enable-specified interface addresses is
less than 32.
<Num>: Number of enable-defined interfaces in pim6 configuration
definition
pim6:ssm is not defined Though the "ssm-join" command has been defined, the "ssm"
command has not been defined.
pim6:the number of PIM-SSM groups is set up
exceeding the maximum
The number of group addresses of IPv6 PIM-SSM exceeds the
allowable limit. The maximum number is 1.
pim6: the total number of group prefix should
not be greater than 128
The total number of IPv6 group addresses in a rendezvous point
candidate exceeds the maximum number of addresses. Set so that
the total number of group addresses is within 128.
pim6: unsupported interface <Interface
Name> specified
The interface specified in pim6 definition cannot be set. Do not
specify the interfaces below because they are not supported in an
IPv6 multicast.
1. Interface in which IPv6 address cannot be defined
2. Tunnel interface
<Interface Name>: Specified interface name
<Command>: syntax error Syntax error
<Command>: Command name\
Table 5-7 IPv6 Multicast Router Control Information Error Messages (continued)