Filter
Top Products
Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
1-10 GR2K-GA-0014
Ver. 07-02
Parameters
[{-no | -yes}]
Description: Specifies use or no-use of the flow control function.
-no : Not used.
-yes : Used.mParameter
Default:
no
This parameter fixedly specifies the priority of an IPv4 packet that this router
generates or specifies it using a
flow qos command. It is invalid in RP-A1. In
RP-A1, this parameter operates as classify_all_off. The IPv6 packet that this
router generates is controlled by the priority set using a
flow qos command
irrespective of the existence of this option.
This parameter specifies the fixed priority in the IP packet that this router
generates. The priority for each packet type when this parameter is specified is
showninTable1-8onpage1-12.
This parameter specifies the priority, set using a flow qos command, in the IP
packet that this router generates. The priority for each packet type when this
parameter is specified is shown in Table 1-9 on page 1-13.
Default: -classify_all_off
Range of value: None
Description: This parameter specifies the range of a flow list number in
which a COPS agent function can be set to all RPs. It cannot
bechangedwhen"cops_yes"issetinthecopsconfiguration
definition. Also, this parameter cannot be deleted when cops
configuration definition is set.
Default: None (A COPS function is not used.)
Range of value: 1 to 20000 (decimal)
Note 1: The calculation expression for obtaining RP unit yen and
numeric characters is described below.
Number RP unit entries = <Maximum List No.> - <Minimum
ListNo.>+1
An example of calculation for the number of entries is given
below.
For -cops range 1001 - 2000
2000 - 1001 + 1 = 1000
The number of flow list entries that can be set using a COPS
agent function is 1000 in units of RP.
This parameter can set a maximum of 2000 entries per RP.