Filter
Top Products
Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
4-48 GR2K-GA-0014
Ver. 07-02
4.7.12 ISDN Information (Japan Only)
Input Format
VC information Active/non-active state switching of VC vc_enable (VC
active state)
SwitchingofmodeinwhichInverseARPofanATMlineisused
or not used
inverse_arp
(Inverse ARP is
used.)
MTU of ATM line 4470 bytes
Setting of cell loss priority display bit 0 (CLP=0)
Polling interval in VC state monitoring function using F5-OAM
loop-back cell (seconds)
no (The VC state
monitoring
function does not
operate.)
Number of response reception confirmation times during VC
failure recovery in VC state monitoring function using F5-OAM
loop-back cell (times)
3times
Number of non-response confirmation times during VC failure
generation in VC state monitoring function using F5-OAM
loop-back cell (times)
5times
Request transmission interval during VC failure generation/
recovery in VC state monitoring function using F5-OAM
loop-back cell (seconds)
1 second
*
Note: ISDN settings are only valid in Japan.
Software for using the model GR2000-B overseas currently allows the setting of
ISDN functions. However, since hardware specifications do not support ISDN, a
log message indicating an error is displayed if ISDN configuration definitions are
set. In order to avoid this malfunction, do not set ISDN configuration definitions.
Table 4-11 List of Initial Values That Can Be Set Using ARM Information and Initial
Values During Initial Installation (continued)
Information
Group Name
Information Name Initial Value