Filter
Top Products
Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
5-94 GR2K-GA-0014
Ver. 07-02
5.15 COPS Information
Table 5-15 COPS Information Error Messages
Message Contents
Both are required for pepid and primary. pepid and primary parameters are indispensable.
Both are required for server_password and
cops_password.
Set both server_password and cops_password parameters when
setting an encryption key.
COPS program is editing the configuration,
please try again.
A COPS program is editing the configuration definition. Execute
again after a little while.
COPS program is setting up policy, please try
again.
A COPS program is setting a policy. Execute again after a little while.
cops_password is less than 64 characters. The number of entered characters in a cops password parameter is
out of the prescribed range.
Set it using characters not exceeding 64.
Duplicate key id '<keyid>' The same keyid cannot be set.
Set different keyid.
<Keyid>: Specified keyid.
illegal option -- <option> Illegal option
<option>: Specified option
pepid is less than 14 characters. The number of entered characters in a pepid parameter is out of the
prescribed range.
Set it using characters not exceeding 14.
pepid is required. A pepid parameter is indispensable.
primary is required. A primary parameter is indispensable.
server_password is less than 64 characters. The number of entered characters in a server_password parameter
is out of the prescribed range. Set it using characters not exceeding
64.
The cops parameter of qos is required. The cops parameter of a qos command is required when setting the
COPS configuration definition.
The cops_range parameter of flow is required. The cops_range parameter of a flow command is required when
setting the COPS configuration definition.
The range of average_packet_size is 1024 -
65535.
The input value of an average_packet_size parameter is out of the
prescribed range. Set it in the range of 1024 to 65535.
The range of backup_port is 0 - 65535. The input value of a backup_port parameter is out of the prescribed
range. Set it in the range of 0 to 65535.
The range of key id is 1 - 2147483647. The number of entered characters in a keyid parameter is out of the
prescribed range. Set it in the range of 1 to 2147483647.
The range of primary_port is 0 - 65535. The input value of a primary_port parameter is out of the prescribed
range. Set it in the range of 0 to 65535.
The range of retry_time is 0 - 10. The input value of a retry_time parameter is out of the prescribed
range. Set it in the range of 0 to 10.