Filter
Top Products
Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
5-62 GR2K-GA-0014
Ver. 07-02
5.7 IPv6 Multicast Routing Protocol
Table 5-7 IPv6 Multicast Router Control Information Error Messages
Message Contents
configuration check error Configuration definition check has failed.
mld:address of group definition is not
omissible
No group address is specified on the "smm-join" command definition.
mld:address of source definition is not
omissible
No local address is specified in the "ssm-join" command.
mld:<address> is not in agreement with the
group address set up by ssm
The range of the group address set by the "ssm-join" command does
not coincide with the range of the group address set by the "ssm "
command.
<address>: local address set by the "ssm-join" command
mld:duplicate group <address> clause Duplicate group addresses are specified by the "ssm-join" command.
<address>: local address set by the "ssm-join" command
mld:duplicate source <address> clause Duplicate local addresses are specified within the same "ssm-join"
command
<address>: local address set by the "ssm-join" command
mld:duplicate ssm-join clause Multiple "ssm-join" commands have been set. The maximum
number is 1.
mld:Source prefix(<IPv6 Source address>)
has a narrow scope
The range for specifying local addresses specified by the "ssm-join"
command is invalid. Specify IPv6 addresses other than local
addresses.
<IPv6 source address>: local address specified by the "ssm-join"
command
mld:The combination total of GROUP and
SOURCE exceeded the maximum permitted.
The sum total of groups and sources defined by "ssm-join" exceeds
the allowable limit. Set the sum total of groups and sources to a
maximum of 256.
pim:<IPv6 Group Prefix> is not an IPv6
multicast address
Group addresses specified by IPv6 PIM-SM rendezvous point
candidates must be multicast addresses.
Or the group address specified by the "ssm-join" command of
PIM-SSM is not an IPv6 multicast address.
<IPv6 group prefix>: Specified IPv6 multicast group address
pim:prefix length <Prefixlen> should be
ranged between 8 and 128
The range for specifying prefix length specified by IPv6 PIM-SM
rendezvous point candidates is invalid.
Or the range for specifying prefix length specified by PIM-SMM group
address is invalid.
Set within the range of 8 - 128.
<Prefixlen>: Specified prefix length
pim6: already defined enable or disable for
<Interface Name>
In pim6 definition, enable or disable is specified for the same
interface two times or more. Specify enable or disable only once.
pim6: candidate-bsr is already defined candidate-bsr of pim6 is duplicate-defined. Delete one of the
definitions.
pim6: candidate-bsr priority is already defined candidate-bsr priority of pim6 is duplicate-defined. Delete one of the
definitions.
pim6: candidate-bsr priority value '<Num>'
should be ranged between 0 and 255
The priority level of a BSR candidate is out of the range. Set a value
of 0 to 255.
<Num>: Set priority level
pim6: candidate-rp is already defined candidate-rp of pim6 is duplicate-defined. Delete one of the
definitions.
pim6: candidate-rp priority is already defined candidate-rp priority of pim6 is duplicate-defined. Delete one of the
definitions.
pim6: candidate-rp priority value '<Num>'
should be ranged between 0 and 255
The priority of rendezvous point candidates exceeds the permissible
range. Specify a value from 0 through 255.