Filter
Top Products
Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
5-28 GR2K-GA-0014
Ver. 07-02
bgp4+: external peer must not have the same
AS as we do locally (<As>)
The AS number of a local router was specified using the peer AS
number of an external peer. Do not specify the AS number of a local
router in the peer AS number of an external peer.
<As>: AS number of local router
bgp4+: external peer must not have the same
AS as we do locally member AS (<As>)
The member AS number of a local router was specified using the
peer AS number of an external peer. Do not specify the member AS
number of a local router in the peer AS number of an external peer.
<As>: Member AS number of local router
bgp4+: gateway <IPv6 Prefix> is not global/
site-local/linklocal IPv6 address
Specified gateway is invalid. Specify the global address, site-local
address or linklocal address.
<IPv6 Prefix>: Specified gateway address
bgp4+: gateway not a host address on an
attached network:<IPv6 Prefix>
The specified gateway is not a host address in the connected
network. Define the gateway address in the defined interface
address.
<IPv6 Prefix>: Specified gateway address
bgp4+: Invalid address specified at lcladdr
option
The interface of the specified interface address cannot be found.
Specify the defined interface address.
bgp4+: invalid as_count value at ’<Value>’
not in range 1 to 25
The range of the Ascount value is specified incorrectly.
Specify in the range of 1 to 25.
<Value>: Specified ascount value
bgp4+: invalid BGP4+ localpref value at
’<Metric>’ not in range 0 to 65535
Specified LOCALPREF value is invalid. Specify value within the
range of 0 to 65535.
<Metric>: Specified LOCALPREF value
bgp4+: invalid BGP4+ metric value at
’<Metric>’ not in range 0 to 4294967295
BGP metric value is invalid in BGP4+. Specify value within the range
of 0 to 4294967295.
<Metric>: Specified metric value
bgp4+:invalid community id value at ’<Value>’
not in range 0 to 65535
In the comm-split parameter, the range of Comm_id value is invalid.
Specify a value within the range of 0 to 65535.
<Value>: Specified Comm_id value
bgp4+: invalid hold time value at ’<Value>’ not
in range 0 to 65535
Hold time value is invalid. Specify value within the range of 3 to
65535 or 0.
<Value>: Specified ascount value
bgp4+: invalid policy group number value at
<Group Number> not in range 1 to 16
Policy group number is invalid. Specify a value within the range of 1
to 16.
<Group Number>: Specified masl length
bgp4+: invalid preference value at ’<Value>’
not in range 2 to 255
Preference value is invalid. Specify value within the range of 2 to
255.
<Value>: Specified preference value
bgp4+: local-as may only be used with
external peers
The Local-as option is defined for other than external peers. This
option may only be used for external peers.
bgp4+: member-as must be different
autonomous-system
The AS number to which this device belongs is the same as the
member AS number. Specify the AS number with a different number
from the member AS number.
bgp4+: metric-out option is not supported the
policy group
A Metricout option is specified in the policy group. Specify a
Metricout option on the Export filter side.
bgp4+: multipath-option (all-as) must be set
compare-med (all-as)
For the all-as parameter of multipath-option, the all-as parameter of
compare-med must be set. Specify the all-as parameter of
compare-med when specifying the all-as parameter of
multipath-option.
bgp4+: Number of local-as is more than
maximum permitted(16)
The number of defined local-as options exceeds the maximum
allowable value. Define local-as options of less than maximum 16.
bgp4+: Only External groups may be
Confederation Peer
The confederation parameter is specified by the internal peer. Do not
specify the confederation parameter by using the internal peer.
Table 5-5 Routing Protocol Error Messages (continued)