Filter
Top Products
Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
5-102 GR2K-GA-0014
Ver. 07-02
5.25 Other Error Messages
The following sub-commands (mainly, the open, close, save and copy
sub-commands) are used for other purposes than for editing configuration
definitions.
Table 5-25 Other Error Messages
Message Contents
Bad address. Access to MC card failed. Confirm setting status of MC card by using
show mc command. When MC card is set correctly, wait for access,
then execute again.
Cached configuration file is not created,
current configuration file not be saved.
Because the contents of current configuration information file is not
copied to temporarily saving configuration information file, current
configuration information file is not saved.
Eliminate the error and execute the command again.
1. Confirm the MC card’s mounting status and the remaining
capacity by using the show mc command (*1).
2. Confirm the RM’s CPU use rate using the show “rm cpu”
command (*2).
Can not execute config command in standby
RM.
Config command unavailable in standby RM.
Enter a config command in operation system.
CAUTION: Configuration file copy failed
because cached configuration file create
failed.
Because configuration file cannot be copied to cached configuration
file, configuration file copy failed. Confirm setting status and the rest
of memory size of MC card, and the execute again after eliminating
causes of error.
CAUTION: Configuration file do not copy to
standby RM because standby RM is not
ready.
Standby configuration file copy failed. Confirm setting status and the
rest memory size of standby MC card by using show mc command,
and then execute the command again after eliminating causes of
command.
CAUTION: Configuration file do not modified
to standby RM because configuration file is
opened in standby.
Because standby configuration information is opened, configuration
file copy failed. Close standby configuration, and then execute the
show mc command again.
CAUTION: Configuration file do not modified
to standby RM because standby RM is not
ready.
Because standby configuration information cannot be modified,
configuration file copy failed. Confirm status and operation of the
standby, and then execute the command again.
CAUTION: Current configuration file was
successfully changed. Configuration file do
not modified to standby RM because standby
RM is not ready.
Current configuration file was copied, but because standby
configuration information cannot be modified, standby configuration
information is not reflected. When updating standby configuration
file, confirm status and operation of standby, and then reflect by
using config copy command.
1. Confirm the MC card’s mounting status and the remaining
capacity in the standby system using the show mc command (*1).
2. Confirm the RM’s CPU use rate using the show “rm cpu”
command (*2).
3. Confirm that the standby system RM board has been inserted
into this device correctly.
CAUTION: Current configuration file was
successfu11y changed. Configuration file do
not modified to stand by RM because cached
configuration file create failed.
Current configuration file was copied, but because standby
configuration information cannot be copied to cached configuration
file, standby configuration information is not reflected.
When updating standby configuration file, Confirm setting status and
the rest memory size of standby MC card by using show mc
command, and then reflect by using config copy command after
eliminating causes of error.
CAUTION: Current configuration file was
successfully changed. Configuration file did
not copy to standby RM because standby RM
is not ready.
Current configuration file was copied, but because standby RM is not
ready, standby configuration file copy failed.
When updating standby configuration file, reflect after starting up
standby by using config copy.