Filter
Top Products
Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
5-10 GR2K-GA-0014
Ver. 07-02
Mcr not specified. MCR not specified. Set MCR.
Minimum rate is greater than server rate2. The minimum transmission throughput during control under heavy
congestion exceeds the minimum ratio of 2 of transmission
throughput to the net under changing heavy congestion. Adjust
settings so as to reduce the minimum throughput during control to
below the minimum ratio of 2 of transmission throughput to the net
under changing heavy congestion
Monitored events counter is less than error
threshold.
Link quality monitored event interval is less than the error threshold
of link quality. Set the value so the link quality monitored event
interval is no less than the error threshold of link quality.
NIF board is not mounted. Type of the mounted device is not found. Mount device.
NIF board type is mismatched. Specified type is different from type of mounted device. Specify type
of mounted device.
NIF No. out of range. Specified NIF number exceeds maximum value. Check the NIF
number.
No pvc detection id less than value multiplied
by t391 dte timer and error threshold.
The PVC unavailability message receive count is less than the value
multiplied by the status inquiry request message send interval and
the error frequency used for detecting falling. Set the value so the
PVC unavailability message receive count is no less than the value
multiplied by the status inquiry request message send interval and
the error frequency used for detecting falling.
No such ATM configuration. No such ATM configuration. Confirm the specified name.
No such name <name>. Specified configuration information name not found. Specify existing
definition information name.
No such set index. An entry cannot be set on specified entry number.
Use entry number not exceeding the set number of entries. To add
entries, use the number of set entries +1 for entry value.
No such vp configuration. No such vp configuration. Confirm the specified name or vp value.
Pcr not specified. Pcr not specified. Set PCR.
Phone number not specified. Own phone number not specified. Set the own telephone number to
Dch line.
Relations between aps and line (aps
protection) are inconsistent.
Relations between aps type and line (aps protection) are
inconsistent. If the APS lines are set in the same NIF, set the APS
operation switch to ON.
Relations between aps_protocol, revertive
and directional are inconsistent.
Relations between aps_protocol, revertive and directional are
inconsistent. Set the correct value.
Relations between authentication protocol
and phone number1 are inconsistent.
Relations between authentication protocol and phone number1 are
inconsistent. When authentication protocol is no, set peer’s phone
number and subaddress 1.
Relations between authentication protocol
and user name and password are
inconsistent.
Relations between authentication protocol and user name and
password are inconsistent. When authentication protocol is other
than no, set own user ID and own password.
Relations between authentication protocol
and user name and password are
inconsistent.
Relations between authentication protocol and user name and
password are inconsistent. When authentication protocol is other
than no, set own user ID and own password.
Relations between cir and bc are inconsistent. Authentication burst size is greater than transmission throughput/
8x40. Specify the authentication burst size not exceeding
transmission throughput/8x40.
Relations between echo trial times and echo
success times are inconsistent.
Relations between echo trial times and echo success times are
inconsistent. Set standard value of link quality OK to the trial count of
link quality judge or less.
Relations between inverse arp and local
management (frame relay) are inconsistent.
Although the PVC status check protocol is no, the InARP address
solving execution is on. Turn off the InARP address solving
execution switch.
Table 5-3 Network Interface Error Messages (continued)