Filter
Top Products
Configuration Error Messages
GR2K-GA-0014 5-61
Ver. 07-02
pim: the total number of enable interfaces is
more than the maximum number of interfaces
that this router runs (<Num1>) though it is less
than the max-interfaces value (<Num2>)
The total number of interface addresses set to “enable” in the PIM
definition does not exceed the value (<Num2>) specified for
max-interfaces. But the number exceeds the maximum number of
interfaces running on the system (<Num1>). Set the number of
enable-specified interface addresses to <Num1> or less.
To add an interface definition, take the following steps:
(1) Execute the config apply command.
(2) Execute the restart ipv4-multicast command.
(3) Add an interface address of PIM.
<Num1>: The maximum number of interfaces running on the system.
<Num2>: The number of specified interfaces.
pim: the total number of groups on
candidate-rp is more than the maximum
permitted (128)
The total number of group addresses of rendezvous point candidates
exceeds the maximum capacity. Specify 128 addresses or less.
pim: the total number of interfaces is more
than the maximum permitted (<Num>)
The total number of interface addresses specified in the PIM
definition exceeds the maximum capacity. Set the number of PIM
addresses to <Num> or less.
<Num>: The maximum number of specified interfaces
pim:the number of PIM-SSM groups is set up
exceeding the maximum
The number of PIM-SSM group addresses that have been set
exceeds the maximum limit. The maximum number is 1.
pim: this address is not supported <Group
address>
The group address specified for PIM-SAM rendezvous point
candidates is not supported. For the group address, specify a
Class-D IP address.
<Group address>: Specified multicast group address
<Command>: syntax error Syntax error
<Command>: Command name
Table 5-6 Multicast Router Control Information Error Messages (continued)