Filter
Top Products
Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
5-16 GR2K-GA-0014
Ver. 07-02
Duplicate relay address. Duplicate relay address. Set all of the DHCP relay addresses to
unique.
Duplicate subject IP address. The same IP address is used. Make each IP address unique.
Duplicate vlan. The same VLANs are set in the same physical port. Make settings so
that VLANs in the same RP are unique.
Inconsistency has occurred in a setting of
IPv6 address and NDP.
There is a conflict in the prefixes between the address set by the IP
information and the address set by the NDP information. Designate
the address prefixes correctly.
Interface name not specified. Interface name not specified. Set interface name. Enter a correct
interface name.
Invalid connect type. The connection type is illegal. On an ATM or ISDN PPP line, if the
connection type is "broadcast," you cannot set IPv6.
Invalid critical interface name. The error monitoring interface name is illegal. For the error
monitoring interface name, use a name other than AUX.
Invalid destination IP address. Destination IP address value invalid. Set a correct destination IP
address
Invalid host address. Host address is 0 or ALL 1. Specify the value so host address is
neither 0 nor ALL 1.
Invalid IP address. IP address value invalid. Set a correct IP address.
Invalid name <name>. Entered name of configuration information invalid.
For group: Specify DLCI name on the same RP already defined.
For PPP, frame relay: Specify line name whose line type is serial,
oc3pos,
oc12pos, or name of timeslot.
For DLCI: Specify name set in frame relay.
For timeslot: Specify line name whose line type is pri, j2, bri.
For filter interface, qos ip: Specify line name of the line where IP is
set.
For QoS interface: Specify name set in ethernet, frame relay, dlci,
ppp.
For IP: Specify name set in ethernet, frame relay, dlci, ppp, vc, ISDN
PPP, Group, Tunnel.
For ARP: Specify name set in ethernet, dlci, vc, ISDN PPP.
For Virtual Router: Specify the name of a line other than AUX for
which the IP is set.
For Policy List: Specify the name of a line other than rmEthernet and
AUXforwhichanIPisset.
For Relay Interface: RmEthernet for which an IP is set.
Specify an interface name other than AUX.
<name>configuration information name
Invalid network class. IP address network class does not match subnet mask network
class. Correct IP address network address and subnet mask class.
Invalid policy routing interface name. Policy routing interface name is invalid. For the name of the interface
for policy routing, use a name other than AUX.
IP address is duplicate between interface and
static NDP entry.
The address set by the IP information is duplicated with the address
set by the NDP information. Designate the addresses without
duplication.
IP address not specified. IP address has not been specified. Specify an IP address.
IP configuration not specified. IP routing has not been specified. Specify IP routing.
IP configuration not specified. IP routing has not been specified. Specify IP routing.
IP interface is not defined. You are about to set the relay interface without IP routing.
Before setting the relay interface, make IP routing settings.
MAC address not specified. MAC address has not been specified. Specify MAC address.
Maximum number of IP address are already
defined.
No more IP address can be set. Check the network configurations.
Table 5-4 IP Information Error Messages (continued)