Filter
Top Products
Filtering/QoS Information
GR2K-GA-0014 1-83
Ver. 07-02
Related Information
For the flow control, please refer to the GR2000 Applications Guide.
Precautions
1. Determination of the QoS flow is performed in the order of the list number
specified in the input/output interface in the QoS flow information (the order of
display when
show flow qos is executed).
2. When setting the qos-ip-list (QoS IP frame condition information) or filter-list
(filter list information), this command cannot be set. Delete both the qos-ip-list
and filter-list before setting this command.
3. Rewriting the EXP in the MPLS net has the following restrictions.
ThelistiseffectiveiftheEXPrewritingissetintheoutputsidelist.However,if
setintheinputsidelist,theactionisnotguaranteed.AlwayssettheEXP
rewriting on the output side list.
4. If this command is inputted in the cases where changes are made on the IP
routing protocol information, the IP multicast protocol information, and the
MPLS information, and the
apply command is not being executed, the apply
subcommand is executed before the command is executed, and the changed IP
routing protocol information, IP multicast routing protocol information, and
MPLS information are reflected to the operation.
5. Flow information consumes 101 entries in each RP when address conversion
(nat) is set. Therefore, when address conversion (nat) is set, the maximum entry
count is decreased by 101 per RP capable of flow information definition.
1.1.9 flow qos (IPv6) [ROUTE-OS6]
Input Format
Setting
Setting and changing the global information by each input/output interface.
Setting and changing the flow information.
[Normal packet flow detecting condition] and [Important packet flow detecting
condition]
1. When the high order protocol is other than TCP, UDP, and IGMPv6.