Filter
Top Products
Operation Management Information
GR2K-GA-0014 4-47
Ver. 07-02
Parameters
TheinitialvalueitemsthatcanbesetusingATMInformationandtheinitialvalues
during initial installation are shown in Table 4-11.
Table 4-11 List of Initial Values That Can Be Set Using ARM Information and Initial
Values During Initial Installation
Information
Group Name
Information Name Initial Value
ATM
information
Setting range of VPI and VCI values 3 (VPI=0-63,
CVCI=32-511)
Setting of maximum VP count 64
Setting of service category pattern cbr_cbr_ubr_ubr
Traffic
information
Setting of cell transmission priority in CBR 2
Setting of cell transmission priority in ABR 2
Setting of mcr value in ABR 38kbps
Setting of icr value in ABR 38kbps
Setting of cell transmission priority in UBR 4
Setting of MBS value in VBR 30
Discard threshold of non-priority packet (CLP1) in GFR 1000cells
Discard threshold of priority packet (CLP0) in GFR 1500cells
Setting of cell transmission priority in GFR 3
pcr value of highest priority packet in GFR2 250kbps
Priority frame discard threshold of highest priority queue in GFR2 700cells
Non-priority frame discard threshold of highest priority queue in
GFR2
500cells
Priority frame discard threshold of high priority queue in GFR2 700cells
Non-priority frame discard threshold of high priority queue in
GFR2
500cells
Priority frame discard threshold of middle priority queue in GFR2 700cells
Non-priority frame discard threshold of middle priority queue in
GFR2
500cells
Priority frame discard threshold of low priority queue in GFR2 700cells
Non-priority frame discard threshold of low priority queue in
GFR2
500cells
Setting of cell transmission priority in GFR2 3
VP information VP warning and loop-back function A VP warning and
loop-back function
are used.