Filter
Top Products
Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
1-64 GR2K-GA-0014
Ver. 07-02
Table 1-37 Operating Parameters that Can Be Set for Each Operation
Operation Parameter
Flow Control
1
2
(*1)
3
(*2)
4
5
(*1)
6
(*2)
7
8
(*1)
9
(*2)
10 11 12
13
(*6)
Existence of operating parameter
-action
√√√√√√√√√√√√√
Contract band monitoring
{ -upc <kbps> [-upc_burst
<Size>]| -min_rate <kbps> [-
min_rate_burst <Byte>]| -
max_rate <kbps> [-
max_rate_burst <Byte>]| -
max_rate <kbps> [-
max_rate_burst <Byte>] -
min_rate <kbps> [-
min_rate_burst <Byte>]}
√√ √√ √√
Output priority -priority <No.> x x √ xxxx
Queuing priority
-discard<No.>
xxx xxxx
User priority rewrite
-replace_user_priority <No.>
√
Group number
-group<No.>
√
(∗5)
DSCP rewrite
-replace_dscp <DSCP_Value>
√√√ x
Priority designation by input IP packet
DSCP
-dscp_map
√√√
Abortion at contract band breach.
-penalty_drop
x
(*3)
x(*3 x(*3
)
Queuing priority at contract band
breach.
-penalty_discard <No.>
√
(*4)
DSCP rewriting at contract band breach.
-penalty_dscp <DSCP_Value>
√
(*4)
√
(*4)
EXP rewrite (mpls packet only)
-replace_exp <Value>
√√
Output VC and DLCI designation
-index <Value>
xxxxxxxxxxxx
√
: Indispensable x: Can be set, and default. No mark: Setting is impossible.
*1: This is the operating parameter of contract band monitoring. These conditions cannot be set when
"-min_rate<kbps>[-min_rate_burst<Byte>]" is specified. To guarantee the minimum band, this parameter can only
change the queuing priority of a packet that violates the contract band.
*2: This is the operating parameter of contract band monitoring. These conditions cannot be set when only
"-max_rate<kbps> [-max_rate_burst<Byte>]" is specified. To limit the maximum band, this parameter can only discard
a packet that violates the contract band.
*3: This is the operating parameter of contract band monitoring. Omit these conditions when
"-max_rate<kbps>[-max_rate_burst<Byte>]" is specified.
*4: This is the operating parameter of contract band monitoring. The operation of a packet that violates the contract
band of "-min_rate<kbps>" is specified when "-max_rate<kbps>[-max_rate_burst<Byte>]
-min_rate<kbps>[min_rate_burst<Byte>]" is specified.
*5: No setting is possible on the VLAN line.
*6: Only VLAN lines can be set. In addition, output priority determination and DSCP rewrite cannot be set
simultaneously.