Filter
Top Products
Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
1-174 GR2K-GA-0014
Ver. 07-02
Checks the source and the destination IP addresses, and
upper-level source and destination protocol port numbers by
simultaneously switching the values (synchronized check). To
run the synchronized source and destination IP address
check, specify:
-ip_pair_off.Forthesynchronizedport
number check, specify:
-port_pair_ off (see note 1).
Default:
-pair_synchronized_off
Description: This parameter specifies the ICMP type.
Default: None (ICMP type is not a flow detection condition).
Range of value:
0-255
Description: This parameter specifies the ICMP code.
Default: None (ICMP code is not a flow detection condition).
Range of value:
0-255
Description: This parameter specifies the IGMP type.
Default: None (IGMP type is not a flow detection condition).
Range of value:
0-255
Description: This parameter specifies a connection branch Index number
(DLCI group information or Index specified using VC-Group
information). This parameter selects and sends the specified
DLCI/VC information in a group when it relays a packet that
coincides with QoS IP frame conditions. For the QoS IP frame
conditions under which the connection branch Index number
isset,specifyparameter-out(Outbound)andsetitasQoSIP
frame conditions on the output side when setting IP QoS
information. See 1.2.8 in this guide.
Default: None
Range of value: 0-7
Table1-85 ListofIGMPTypeNumber
IGMP Type No. (HEX) Input Value (Decimal) Name
0x11 17 Membership Query
0x12 18 Version 1 Membership Report
0x13 19 DVMRP protocol
0x16 22 Version 2 Membership Report
0x17 23 Version 2 Leave Group
0x22 34 Version 3 Membership Report