Filter
Top Products
Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
5-98 GR2K-GA-0014
Ver. 07-02
nat:option requires an argument -- service "service" is an essential option with the specified NAT type.
Set the "service" option.
nat:Can not specify "auto" to a source IP
address.
It is not possible to specify pre-translation IP addresses as "auto"
with the specified NAT type.
Set the correct pre-translation IP address and mask length.
nat:Can not specify "auto" to a translation IP
address.
It is not possible to specify post-translation IP addresses as "auto"
with the specified NAT type.
Set the correct pre-translation IP address and mask length.
nat:source: IP address must be network
address,because network mask length is not
32.
The pre-translation IP address is not a network address for the
specified mask length.
Set the correct pre-translation IP address and mask length.
nat:translation: IP address must be network
address,because network mask length is not
32.
The pre-translation IP address is not a network address for the
specified mask length.
Set the correct post-translation IP address and mask length.
nat:NAT translation IP address range over. The post-translation IP address count of the specified range exceeds
the maximum specifiable count of 1 rule.
Set the correct post-translation IP address range.
nat:NAT translation IP address range count
over.
The post-translation IP address count of the specified range exceeds
the maximum specifiable count of 1 rule.
Set the correct post-translation IP address range.
nat:Unmach NAT IP address count. The pre-translation IP address count of the specified range does not
coincide with the post-translation IP address count of the specified
range in static NAT.
Set the pre-translation IP address count of the specified range the
same as the post-translation IP address count of the specified range.
Can not set nat configuration because
qos_ip_list or filter_list configuration is already
defined.
It is not possible to set nat configuration information because
qos_ip_list or filter_list is set.
It is necessary to delete "qos_ip_list" or "filter_list" in order to set nat.
Can not set nat because there are 2000
entries in all or more, nat configuration and
flow configuration.
It is not possible to set nat configuration information because the
total entry count of nat configuration information and flow
configuration information that can be set per RP exceeds the RP
settable entry count.
Delete flow configuration information.
Can not set nat because nat reservation entry
is used by flow configuration.
It is not possible to set nat configuration information because
reserved entries of nat configuration information are being used by
flow configuration information.
Re-reflect configuration information by the "config copy" command in
order to set nat configuration information.
Can not set nat configuration,qos_ip_list or
filter_list configuration simultaneously.
It is not possible to simultaneously set nat configuration information
and "qos_ip_list" or "filter_list" in configuration information files.
Delete "qos_ip_list" or "filter_list" in order to set nat configuration
information.
Or, delete nat configuration information in order to set "qos_ip_list" or
"filter_list."
Table 5-18 Address Translaion Information Error Messages (continued)