Filter
Top Products
Filtering/QoS Information
GR2K-GA-0014 1-45
Ver. 07-02
Description: ThesubjectinterfacenamesetintheIPinformationorthe
IP-address information is designated. (The IP information or
IP-address information should have been set before inputting
this command.) The RM Ethernet is not supported. For details,
refer to Table 1-5.
Default: No default is possible.
Description: Inbound/Outbound is designated. Either one or both of the
Inbound/Outbound can be set simultaneously.
in :Inbound (designation on the frame input side)
out:Outbound (designation on the frame output side)
Default: No default is possible.
Description: The flow control is nullified by each input/output interface.
Default: No default is possible.
Description: The list numbers are designated.
Default: Defaultispossibleonlyforthecaseofindication.Allthelists
are indicated at default.
Range of value: IPv6 filter list: 40001 to 60000 (decimal)
Description: Specifies the range of a list number. This parameter can be
specified only when a blank list number is displayed.
Default: Therangeofthelistnumbertobedisplayedcorrespondstoall
list numbers.
Range of value: IPv4 filter list: 1 to 20000 (decimal)
IPv6 filter list: 40001 to 60000 (decimal)
Description: Displays the blank list number.
Default: Cannot be omitted when the blank list number is displayed.
Description: Displays the top blank list number in the specified range.
Default: Cannot be omitted when the top list number of a blank list
number is displayed.
Flow detecting condition parameter
Description: The high-order protocol numbers or protocol names are
designated. If all protocols are taken as the object, IP is
designated.