Filter
Top Products
e-STUDIO3511/4511 CONTROL PANEL 5 - 4 November 2003 © TOSHIBA TEC
5
No. Message State of equipment Note
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
READY
(SADDLE STITCH
TRAY FULL)
READY
(CHANGE DRAWER
TO CORRECT
PAPER SIZE)
Ready for bypass
feeding
COPYING
Auto Start
Close Large Capacity
Feeder
Close Large Capacity
Feeder Door
Place Doc. Feeder in
the down position
Insert key copy
counter
Place originals in the
document feeder
Change direction of
original
Place last %d
originals in doc.
feeder entrance tray
Cannot copy this
original
Add paper
Cannot duplex this
size
Cannot use this
media type
Copy size: A4/LT
only
Copy size: A4/LT and
A4-R/LT-R
CHANGE DRAWER
TO CORRECT
PAPER SIZE
Change drawer to
correct media type
Saddle stitcher tray is full of paper
- Scanning is enabled
Incorrect paper size setting
Paper is set on the bypass tray
At the copying state
Auto Start is set during printing
LCF drawer is not installed when feeding
from LCF is set
LCF cover is open when feeding from LCF is
set
RADF is open when original is placed on
RADF
Key copy counter not inserted
Displayed when the conditions are set and
START button is pressed with no original
placed
Displayed when the direction of original
placed is different from the setting
Paper jam occurred during copying (RADF
scanning)
Displayed when the original which is not
allowed to be copied is placed
Displayed when the paper in selected drawer
is running out
Displayed when the paper size which is not
specified for duplex copying is set
Displayed when the paper size which is not
specified for the functions such as stapling or
hole punching is set
Displayed when the paper size which is not
specified for “Book-type duplex copying” or
“Dual-page” is set
Displayed when the paper size which is not
specified for “Rotate Sort”
Displayed when the selected paper size is
not in the drawer
Displayed when the selected media type is
not in the drawer
Cleared by pressing [RESET] button
or [STOP] button
Cleared by installing LCF drawer
Cleared by closing the cover
Cleared by closing RADF
Cleared by inserting key copy
counter
Cleared by setting the original
Not printed out