Filter
Top Products
e-STUDIO3511/4511 DRUM RELATED SECTION 11 - 16 November 2003 © TOSHIBA TEC
11
(F-2) Charger cleaner motor
(1) Take off the discharge LED unit ( Chapter
11.7 (F-1)).
(2) Disconnect the joint connector of the charger
cleaner motor.
(3) Remove 1 screw and take off the charger
cleaner motor unit.
(4) Remove 2 screws and take off the gear bracket
and motor guide.
(5) Remove 2 screws and take out the charger
cleaner motor from the motor bracket by
rotating it upward.
Fig. 11-726
Fig. 11-727
Fig. 11-728
Motor guide
Gear bracket
Fig. 11-729
(F-3) Charger cleaner detection switch
(1) Take off the charger cleaner motor unit (
Chapter 11.7 (F-2)).
(2) Separate the discharge LED unit into two parts.