Filter
Top Products
e-STUDIO3511/4511 TRANSFER/TRANSPORT UNIT 14 - 18 November 2003 © TOSHIBA TEC
14
Fig. 14-747
Fig. 14-748
[L] 2nd transfer roller position detection sensor
(1) Take off the 2nd transfer unit
( Chapter 14.7 [J]).
(2) Take off the case ( Chapter 14.7 [K]).
(3) Disconnect 1 connector. Then take off the 2nd
transfer roller position detection sensor.
[M] Paper clinging detection sensor
(1) Take off the transfer belt unit
( Chapter 14.7 [A]).
(2) Open the ADU and 2nd transfer unit.
(3) Remove 1 screw to slide the bracket downward.
Then disconnect 1 connector.
2nd transfer roller
position detection
sensor
Bracket
Fig. 14-745
Fig. 14-746
(7) Remove 1 screw and the pin. (Front side)
(8) Remove 1 screw and the pin. (Rear side)
(9) Disconnect 1 connector and take off the case.
(10) Remove 1 clip and take off the 2nd transfer
roller contact clutch.
Pin
Pin
Case
Clip
2nd transfer roller
contact clutch
04/05